The Bandit™ DC Power Supply by Eagle View
SKU:
EVBPS
$300.00
$300.00
per item
Designed specifically for tattooing and optimized to smoothly run both standard coil and rotary tattoo machines utilizing direct currents. This compact Power Supply integrates an ABS plastic enclosure with rubber side grips for easy handling. The 3M polycarbonate overlay resists scratches, will not fade over time and is easy to wipe down. All buttons and knobs are illuminated.
Sold out
|
|
|
Designed specifically for tattooing and optimized to smoothly run both standard two-coil and rotary tattoo machines utilizing direct currents. This compact Power Supply integrates an ABS plastic enclosure with rubber side grips for easy handling. The 3M polycarbonate overlay resists scratches, will not fade over time and is easy to wipe down. All buttons and knobs are illuminated through barrier film protection. The Bandit DC Power Supply combines on demand power and reliability providing the Tattooer with consistent currents throughout the tattoo cycle resulting in Ultra-Pure DC (direct current) Power. Extreme filtering through over 4,000 microfarads of capacitance minimizes machine resonance, vibration, chatter spots and increases needle push-pull torque. The voltage adjustment utilizes a Digital Rotary Encoder with the adjustment shaft rotating around small magnets to send electronic signals to control voltage. Comparable to the clean and pure analog linear DC voltage from a marine or car battery with 1% output ripple and noise. This allows each artist to work at a quicker more efficient rate. The result is a faster tattoo process with minimal damage to your customer's skin.
|
Power Supply Features
Power Output Features
Included With Each Purchase
|
Ultra-Pure DC Power
Standard power supply units or AC power supply units run on alternate currents. No matter how fancy they look, if measured in microfarads these units produce about 1,500uF which is around three times less efficient than any Eagle View DC Power Supply. Implementing state of the art engineering we transformed the AC power coming from the adapter into direct currents inside the enclosure. Minimal power is needed when the needle is on its way up so just about any power supply will work. However on its way down the needle needs at least twenty times more power to drive it plus the additional load of penetrating the skin, the demand is even higher. This means there is no collapse on the way up because the up and down stroke of the needle run at the same speeds, allowing the artist to work at a quicker more efficient rate. Eagle View uses quality craftsmanship to bring you the only all digital and true DC power supply of its kind. Pedal Lock Feature
To keep the Tattoo machine running without using the foot pedal engage the pedal lock feature on The Bandit by simply pressing down and releasing the voltage adjustment knob. To unlock the pedal press down and release the voltage adjustment knob again or tap the foot pedal. Multi-Memory Settings
There are two independent memory settings that allow you to store two different voltage levels, these settings may be used for a Liner, Shader or anytime you need to quickly switch between different tattooing levels. |
